Re-advertisement: Quotations are hereby invited for the following: Manufacturing and supply of a new palisade fencing and gate at SENTECH Cape Town Offices. Scope of works: - Manufacture and supply of a new fence and gate with razor wire Y brackets and strand wires at Sentech Cape Town offices as per the specifications: Pales: • Splayed, 50mm x 50mm equal angle wide pales x 4mm thick rolled formed with stiffening centre rib. Horizontal bearers: • 50mm x 50mm x 4mm equal angle standard bearers; • Punched to locate pales @ 170mm centre to centre with a 13mm diameter hole; • Pales should be bolted with 12mm zinc plated cup square bolts and snap nuts; • Bearer ends should be punched with a 13mm diameter slot for easy bolt location & assembly. Posts: • 76 x 76 x 3mm posts with a welded post cap. Brackets: • 76mm 90° post brackets; • 76mm 180° post brackets; • 76mm end brackets. Bolts: • 12mm zinc plated cup square bolts and snap nuts. Y brackets: • Each post is to have 500mm Y bracket bolted to the top of each post; • Brackets to be drilled to carry 6 straining wires for razor coil. Razor coil: • 450mm galvanised razor coil is to run continuously above the top fence and must be attached to 6 x fully galvanised straining wires for razor coil. Panels: • Panels are to be made of 3m panels with a centre support in the middle, except where panels are less that 3m in length. Gate: • Gate to be 1.5m single gate, 2.4m high palisade type as per fence, with a shooter that can be locked. (Ausschreibung №89226197de)